Installation Procedure
- Install the infotainment unit (3).
- Install the infotainment unit to instrument panel retaining screws (1) and tighten to 2 N.m (18 lb in).
- Connect the left side infotainment unit electrical connectors (1 and 2 where applicable).
- Connect the right side infotainment unit electrical connectors (1 and 2 where applicable).
- Install the left and right side instrument panel lower extension panels. Refer to Instrument Panel Extension Replacement .
- Install the driver side instrument panel lower trim panel assembly. Refer to Knee Bolster Replacement .
- Install the instrument panel compartment assembly. Refer to Instrument Panel Compartment Replacement .
- Install the infotainment fascia. Refer to Driver Information Display Replacement .
- Refer to Control Module References .
NOTE:
Make sure to guide the infotainment unit (3) over the aligning lugs (2).
CAUTION:
Refer to Fastener Caution
.
NOTE:
Make sure to close the retaining lever on the infotainment electrical connector (2) once connected.