LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System & Fuel System - 3.6L - Introduction) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying MAP Sensor & ETC Electrical Connectors
    GM1838990Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Disconnect the engine wiring harness electrical connector (1) from the manifold absolute pressure (MAP) sensor.
    3. Fig 2: View Of MAP Sensor & Bolt
    GM1838999Courtesy of GENERAL MOTORS CORP.
  3. Remove the MAP sensor bolt and sensor.
scientia non olet · About LEMON Manuals