LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System & Fuel System - 3.6L - Introduction) >> Repair Instructions >> Intake Manifold Tuning Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Identifying EVAP Canister Purge Solenoid, Ignition Coils & Intake Manifold Tuning Valve
    GM1839426Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
  2. Disconnect the engine wiring harness electrical connector (1) from the intake manifold tuning valve.
  3. Unbolt and reposition the power steering pump reservoir bracket.
    4. Fig 2: View Of Intake Manifold Tuning Valve & Bolts
    GM1839938Courtesy of GENERAL MOTORS CORP.
  4. Remove the intake manifold tuning valve bolts.
  5. Remove the intake manifold tuning valve.
scientia non olet · About LEMON Manuals