LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System & Fuel System - 3.6L - Introduction) >> Repair Instructions >> Intake Manifold Tuning Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Intake Manifold Tuning Valve & Bolts
    GM1839938Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the intake manifold tuning valve O-ring seal with clean engine oil.
  2. Install the intake manifold tuning valve.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the intake manifold tuning valve bolts and tighten to 10 N.m (89 lb in.
  4. Position the power steering pump reservoir bracket and install the bolts and tighten to 9 N.m (80 lb in).
    5. Fig 2: Identifying EVAP Canister Purge Solenoid, Ignition Coils & Intake Manifold Tuning Valve
    GM1839426Courtesy of GENERAL MOTORS CORP.
  5. Connect the engine wiring harness electrical connector (1) to the intake manifold tuning valve.
  6. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals