LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 7 (Engine Control System & Fuel System - 3.6L - Introduction) >> Repair Instructions >> Air Cleaner Assembly Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of MAF/IAT Sensor Wiring Harness Connector
    GM1838957Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct Replacement .
  2. Disconnect the engine wiring harness electrical connector from the mass airflow (MAF)/intake air temperature (IAT) sensor.
    3. Fig 2: View Of Air Cleaner Housing Rear Bolt & A/C Condenser/Evaporator Tube Clamp
    GM1838002Courtesy of GENERAL MOTORS CORP.
  3. Remove the air cleaner housing rear bolt.
  4. Reposition the air conditioning (A/C) condenser and evaporator tube clamp as required.
    5. Fig 3: View Of Air Cleaner Assembly
    GM1838005Courtesy of GENERAL MOTORS CORP.
  5. Remove the air cleaner assembly from the upper tie bar.
scientia non olet · About LEMON Manuals