LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G6 Base, 2D Coupe >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 6 (Engine Control System & Fuel System - 3.5L - Introduction) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of CKP Sensor (7X)
    GM15969Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the crankshaft position (CKP) sensor electrical connector.
  3. Remove the CKP sensor bolt.
  4. Remove the CKP sensor.
  5. Inspect for wear, cracks, or leakage if the sensor is not being replaced.
scientia non olet · About LEMON Manuals