Installation Procedure

Fig 1: Identifying Tie Rod Inner Jam Nut

Courtesy of GENERAL MOTORS CORP.

NOTE: Inspect the rack and pinion inner tie rod threads for any damage or debris. Clean, repair, or replace the rack and pinion inner tie rod as needed.

Install a rack and pinion inner tie rod nut.

Fig 2: View Of Outer & Inner Tie Rods

Courtesy of GENERAL MOTORS CORP.

NOTE: Install the rack and pinion outer tie rod end the same number of complete rotations counted when removing it prior.

Thread the rack and pinion outer tie rod end onto the rack and pinion inner tie rod.

Fig 3: View Of Tie Rod End & Steering Knuckle

Courtesy of GENERAL MOTORS CORP.

Install the rack and pinion outer tie rod end to the steering knuckle.

CAUTION: Refer to Fastener Caution .

Install a new rack and pinion outer tie rod end nut.
Tighten: Tighten the nut to 25 N.m (18 lb ft) plus 90 degrees.
Tighten the rack and pinion inner tie rod nut.
Install the front tire/wheel. Refer to Tire and Wheel Removal and Installation .
Adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .