LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2009 >> G5 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 10 (Supplemental Inflatable Restraint System) >> Diagnostic Information and Procedures >> DTC B1370 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Pontiac G5 and 2008 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: When removing connectors inspect for damage or corrosion. Damage or corrosion in the following requires repair or replacement of the affected.
  • SDM
  • SDM wiring harness
  1. Ignition OFF, remove the underhood AIRBAG fuse.
  2. Ignition ON, connect a test lamp between the B+ side to the fuse and ground. The test lamp should illuminate.
  3. Ignition OFF, install the underhood AIRBAG fuse.
  4. Disconnect the harness connector at the SDM.
  5. Ignition ON, verify a test lamp illuminates between ignition circuit terminal 33 and ground.
    • If the test lamp does not illuminate, test the ignition circuit for short to ground or an open/high resistance.
  6. If all circuits test normal, replace the SDM.
scientia non olet · About LEMON Manuals