LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 150 (Steering Linkage) >> Repair Instructions >> Relay Rod Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the relay rod to the vehicle.
    2. Fig 1: Seating Idler Arm Tapers
    GM689037Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  2. Use installer J 29193  or installer J 29194  to seat the idler arm and pitman arm to the relay rod. See Special Tools .

    Tighten:  Tighten the installer to 54 N.m (40 lb ft).

    3. Fig 2: View Of Idler Arm
    GM793272Courtesy of GENERAL MOTORS CORP.
  3. Install the new pitman arm nut.

    Tighten:  Tighten the nut to 60 N.m (44 lb ft).

  4. Install the new idler arm nut.

    Tighten:  Tighten the nut to 60 N.m (44 lb ft).

  5. Connect the steering linkage outer tie rods to the steering knuckles. Refer to Steering Linkage Outer Tie Rod Replacement .
  6. Install the steering linkage shock absorber. Refer to Steering Linkage Shock Absorber Replacement .
  7. Adjust the front toe. Refer to Front Toe Adjustment .
scientia non olet · About LEMON Manuals