LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Vibe Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 90 (Supplemental Inflatable Restraints) >> Repair Instructions >> Inflatable Restraint Front End Sensor Replacement

Inflatable Restraint Front End Sensor Replacement

WARNING: This page is about a different car, the 2008 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Inflatable Restraint Front End Sensor
GM1943747Courtesy of GENERAL MOTORS CORP.
Callout Component Name
CAUTION: Refer to SIR Inflator Module Handling and Storage Caution .

Preliminary Procedure

  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the engine protection shield. Refer to Engine Protection Shield Replacement .
1 Inflatable Restraint Front End Discriminating Sensor - Right
NOTE: Refer to Fastener Notice .

Procedure

  1. Disconnect the electrical connection.
  2. Loosen the front end discriminating sensor bolt. (Qty: 1)
  3. Enable the SIR system. Refer to SIR Disabling and Enabling .

Tip:  The bolt is an integral part of the sensor and should remain with the sensor.

Tighten:  10 N.m (89 lb in)
2 Inflatable Restraint Front End Discriminating Sensor - Left
NOTE: Refer to Fastener Notice .

Procedure

  1. Disconnect the electrical connection.
  2. Loosen the front end discriminating sensor bolt. (Qty: 1)
  3. Enable the SIR system. Refer to SIR Disabling and Enabling .

Tip:  The bolt is an integral part of the sensor and should remain with the sensor.

Tighten:  10 N.m (89 lb in)
scientia non olet · About LEMON Manuals