Installation Procedure
WARNING: This page is about a different car, the 2009 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
- Install the ball joint (3) and the nut to the knuckle (2). If the vehicle has the 1.8L VIN 8 engine, tighten the nut to 103 N.m (76.0 lb ft). If the vehicle has the 2.4L VIN 0 engine, tighten the nut to 123 N.m (91 lb ft). With either engine, tighten the nut up to 1/6 additional turn in order to insert the cotter pin.
- Install a NEW cotter pin to the ball joint stud. Bend the cotter pin ends in order to retain the nut.
- Install the ball joint to the lower control arm.
- Install the bolt (3) and the 2 nuts (1, 2). Tighten the nuts and the bolt to 89 N.m (66 lb ft).
- Lower the vehicle.
- Measure the wheel alignment. Adjust the wheel alignment if necessary. Refer to Wheel Alignment Measurement .
CAUTION:
Refer to Fastener Caution
.
NOTE:
Do not loosen the nut (4) in order to insert the cotter pin (5).