Windshield Washer Pump Circuit Test
- Ignition OFF, disconnect the harness connector at the windshield washer fluid pump.
- Test for less than 1 ohm of resistance between the ground circuit terminal 1 and ground.
- If greater than 1 ohm, repair the ground circuit for an open/high resistance.
- Ignition ON, verify that a test lamp illuminates between the washer pump control circuit terminal 2 and ground while pressing the washer switch.
- If the test lamp does not illuminate, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the underhood fuse block.
- If all the circuits test normal, replace the windshield washer fluid pump.