LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Solstice Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 104 (Cruise Control System) >> Repair Instructions >> Distance Sensing Cruise Control Aiming >> DSCC Aiming Procedure

DSCC Aiming Procedure

WARNING: This page is about a different car, the 2008 Cadillac DTS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition completely off.
  2. Install BO-047670  to the front of the DSCC module (3). See Special Tools .
  3. Check that the spring tension rods are installed in the proper position and that all three legs on BO-047670  are touching the ACC housing before continuing. See Special Tools .
  4. Turn the laser beam on.
  5. Adjust the horizontal aim screw (2) and vertical aim screw (4) of the DSCC module until the laser beam is in the center of the cross hairs on the vertical wall.
  6. Turn off the laser beam and remove BO-047670  . See Special Tools .
  7. Install a scan tool.
  8. Turn ON the ignition, with the engine OFF.
    9. IMPORTANT: If a test drive is needed it is preferred that it be conducted on the freeway and the driver should keep a distance of at least 50 m (164 ft) behind the tracking target.
  9. With the scan tool, perform the Factory Reset for the DSCC module in the Body and Accessories, Cruise Control Special Functions.
  10. Install the grille and front compartment sight shields. Refer to Fascia Grille Replacement .
scientia non olet · About LEMON Manuals