LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Solstice Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 417 (Fixed And MOVEABLE Windows System) >> Diagnostic Information and Procedures >> DTC B0283 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Saturn Sky and 2010 Pontiac Solstice. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the X2 harness connector at the HVAC control module.
  2. Disconnect the REAR DEFOG relay.
  3. Test for less than 1 ohm between the ground circuit terminal 86 and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  4. Connect a test lamp between the control circuit terminal 85 and ground circuit terminal 86.
  5. Ignition ON, command the Rear Defog Relay ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, replace the BCM.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the BCM.
  6. Connect the REAR DEFOG relay.
  7. Connect a test lamp between the defog indicator control circuit terminal F and ground.
  8. Command the rear window defogger ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.
    • If the test lamp is always ON, test the control circuit for a short to voltage. If the circuit tests normal, test or replace the REAR DEFOG relay.
    • If the test lamp is always OFF, test the control circuit for a short to ground or an open/high resistance. If the circuit tests normal, test or replace the REAR DEFOG relay.
  9. If all circuits test normal, test or replace the HVAC control module.