LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 370 (Data Communication System) >> Diagnostic Information and Procedures >> Scan Tool Does Not Communicate with Keyword Data Line >> Test Description

Test Description

WARNING: This page is about a different car, the 2008 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.

The numbers below refer to the step numbers on the diagnostic table.

  1. 3:  A partial malfunction in the serial data circuit uses a different procedure from a total malfunction of the serial data circuit. The following modules communicate on the serial data circuit.
    • Communication interface module (OnStar®)
    • Electronic brake control module (EBCM)
    • Inflatable restraint sensing and diagnostic module (SDM)
    • Instrument panel cluster (IPC)
    • Radio
  2. 5:  DLC terminals 2 and 5 provide the connection to the serial data circuit and the signal ground circuit respectively.
  3. 7:  A poor connection at splice pack S232 will cause this condition but will not set a DTC.
  4. 8:  An open in the serial data circuit between the DLC and splice pack S232 will prevent the scan tool from communicating with any module on the network. This condition will not set a DTC.
Step Action Yes No
Schematic Reference: Data Communication Schematics 
Master Electrical Component List
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2
  1. Turn ON the ignition, with the engine OFF.
  2. Perform the Vehicle DTC Information function on the scan tool under Computer/Integrating Systems menu.
Are any DTC's retrieved from any module?		 Go to Diagnostic Trouble Code (DTC) List - Vehicle Go to Step 3 
3  Did the scan tool communicate with any module on the serial data circuit? Go to Step 4  Go to Step 5 
4 Diagnose the non-communicating module by referring to the appropriate section.
Did you complete the action?		 Go to Diagnostic System Check - Vehicle -
5 
  1. Turn OFF the ignition.
  2. Disconnect the scan tool from the data link connector (DLC).
  3. Inspect for poor connections at the DLC terminals 2 and 5. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?		 Go to Diagnostic System Check - Vehicle Go to Step 6 
6 Test the DLC ground circuit at terminal 5 for an open. Refer to Circuit Testing and Wiring Repairs .
Did you find and correct the condition?		 Go to Diagnostic System Check - Vehicle Go to Step 7 
7 
  1. Disconnect the splice pack S232.
  2. Inspect for poor connections at the splice pack SP205. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?		 Go to Diagnostic System Check - Vehicle Go to Step 8 
8  Repair the serial data circuit between the DLC and the splice pack S232 for an open. Refer to Circuit Testing and Wiring Repairs .
Did you complete the action?		 System OK -
scientia non olet · About LEMON Manuals