LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 325 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
    CAUTION: If the vehicle interior is exposed to moisture and becomes soaked up to the level of the sensing and diagnostic module (SDM), the SDM and SDM harness connector must be replaced. The SDM could be activated when powered, which could cause airbag deployment and result in personal injury.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
    2. Fig 1: SDM Assembly And Fasteners
    GM819439Courtesy of GENERAL MOTORS CORP.
  2. Remove the console in order to access the sensing and diagnostic module (SDM) (1). Refer to Front Floor Console Replacement .
  3. Remove the under seat duct.
  4. Remove the SDM electrical connectors.
  5. Remove the 3 SDM fasteners (2).
  6. Remove the SDM assembly (1) from the vehicle.
scientia non olet · About LEMON Manuals