LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 325 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Sensing and Diagnostic Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: SDM Assembly And Fasteners
    GM819439Courtesy of GENERAL MOTORS CORP.
  1. Install the SDM assembly (1) into the vehicle, taking care to ensure that the connectors are pointing toward the rear of the vehicle.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the 3 SDM fasteners (2).

    Tighten:  Tighten the fasteners to 17.5 N.m (13 lb ft).

  3. Install the SDM electrical connectors.
  4. Install the under seat duct.
  5. Install the center console and then install the rear console. Refer to Front Floor Console Replacement .
  6. Enable the SIR system. Refer to SIR Disabling and Enabling .
  7. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals