LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> Grand Prix Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 166 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Front End Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Pontiac Grand Prix. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove any dirt, grease, or other impurities from the mounting surface.
    2. Fig 1: View Of Sensor, CPA & Yellow Sensor Harness Connector
    GM809058Courtesy of GENERAL MOTORS CORP.
  2. Connect the harness connector (3) to the sensor (1).
  3. Install the orange CPA (2) into the yellow sensor harness connector (3).
    4. Fig 2: Inflatable Restraint Front End Sensor Bolts
    GM809051Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  4. Position the sensor (2) horizontally on the upper radiator core support (3).
  5. Point the arrow on the sensor toward the front of the vehicle.
  6. Install the sensor bolts (1).

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  7. Enable the SIR system. Refer to SIR Disabling and Enabling .
  8. Install the radiator upper air baffle and deflector. Refer to Radiator Air Upper Baffle and Deflector Replacement .
scientia non olet · About LEMON Manuals