Installation Procedure

Fig 1: Battery Positive & Negative Cables

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the positive battery cable (2) to the starter motor BAT terminal.
Install the positive battery cable nut (3) to the starter.
Tighten: Tighten the nut to 10 N.m (89 lb in).
Ensure that the engine harness ground terminal (5) is installed on the transaxle stud prior to installing the engine ground cable.
Install the engine ground cable (6) to the transaxle stud.
Install the transaxle stud nut (1).
Tighten: Tighten the nut to 30 N.m (22 lb ft).

Fig 2: Battery Cable Retainers

Courtesy of GENERAL MOTORS CORP.

Fig 3: View Of Ground Wire

Courtesy of GENERAL MOTORS CORP.

Install the battery cable harness retaining clips (1, 4, and 5) to the front rail and fan shroud.
Position the wire (2) to the top rail, and install the ground wire bolt (3).
Tighten: Tighten the bolt to 10 N.m (89 lb in).

Fig 4: View Of Bussed Electrical Center

Courtesy of GENERAL MOTORS CORP.

Install the BEC to the strut tower.
Install the positive battery lead terminal (2) to the BEC.
Install the positive battery cable junction block lead nut (1).
Tighten: Tighten the nut to 10 N.m (89 lb in).
Install the positive battery cable junction block cover.

Fig 5: View Of Right Front Of Engine Compartment

Courtesy of GENERAL MOTORS CORP.

Connect the I/P harness electrical connector (5) to the battery current sensor (6).
Connect the battery cable connector (3) to the inline I/P harness electrical connector (4).
Install the positive battery terminal from the battery.
Tighten the positive battery terminal nut and position the cover (2)
Tighten: Tighten the nut to 15 N.m (11 lb ft).
Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (L26) or Battery Negative Cable Disconnection and Connection (LS4) .