Frontal Inflator Module Deployment
WARNING: This page is about a different car, the 2009 Saturn Outlook, 2009 GMC Acadia, 2009 Chevrolet Traverse, and 2009 Buick Enclave. However, it is still accessible from the selected car via links, so may be relevant.
After a collision involving air bag deployment, replace the following components.
NOTE:
The front passenger seat is equipped with a PPS, which detects an occupant. If the requirements for disabling the I/P air bag are met then the PPS will communicate with the sensing and diagnostic module (SDM) to disable/turn OFF the I/P air bag, even in a accident. For more information on the PPS refer to SIR System Description and Operation .
- Inflatable restraint I/P module, if deployed and after performing the necessary inspections listed above
- Inflatable restraint steering wheel module
- Inflatable restraint SDM
- Inflatable restraint front end sensor, left/right
- Inflatable restraint seat belt pretensioners
Perform additional inspections on the following components.
- Steering wheel module coil and the coil wiring pigtail-Inspect for melting, scorching, or other damage due to excessive heat.
- Mounting points or mounting hardware for the I/P, steering wheel module, SDM, and pretensioners-Inspect for any damage and repair or replace each component as needed.