LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G8 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2) >> Repair Instructions >> Knock Sensor Replacement - Bank 2 >> Installation Procedure

Installation Procedure

    Fig 1: Identifying KS To Engine Block Retaining Bolt
    GM1949901Courtesy of GENERAL MOTORS CORP.
  1. Install the KS (2) to the engine.
    2. NOTE: Refer to Fastener Notice .
  2. Install the KS to engine block retaining bolt (1).

    Tighten:  Tighten the KS bolt (1) to 23 N.m (17 lb ft).

    3. Fig 2: Identifying KS Electrical Connector & K Sensor
    GM1949900Courtesy of GENERAL MOTORS CORP.
  3. Install the KS electrical connector (1) to the K sensor (2).
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals