LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G8 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2) >> Repair Instructions >> Knock Sensor Replacement - Bank 1 >> Installation Procedure

Installation Procedure

    Fig 1: Identifying KS To Engine Block Retaining Bolt
    GM1949898Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the KS (3) to engine block retaining bolt (2).

    Tighten:  Tighten the KS bolt to 23 N.m (17 lb ft).

    2. Fig 2: Identifying Knock Sensor (KS) Electrical Connector
    GM1949898Courtesy of GENERAL MOTORS CORP.
  2. Install the knock sensor (KS) electrical (1) connector to the KS (2)
  3. Lower the vehicle.
scientia non olet · About LEMON Manuals