LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G8 Base >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 3.6L - Introduction (2 Of 2) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying CKP Sensor To Engine Block Retaining Bolt
    GM1949785Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor (2) to the engine block.
    2. NOTE: Refer to Fastener Notice .
  2. Install the CKP sensor to engine block retaining bolt (1).

    Tighten:  Tighten the crankshaft position sensor bolt to 10 N.m (89 lb in).

    3. Fig 2: Identifying CKP Electrical Connector
    GM1949783Courtesy of GENERAL MOTORS CORP.
  3. Connect the CKP electrical connector (3) to the CKP sensor.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals