LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G8 Base >> Repair and Diagnosis >> Electrical >> Charging Systems >> Battery, Charging System And Starting System >> Repair Instructions >> Generator Replacement (6.0L Engine) >> Removal Procedure

Removal Procedure

    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the engine cover. Refer to Engine Cover Replacement .
  3. Remove air filter assembly. Refer to Air Cleaner Assembly Replacement .
  4. Remove the induction tube from throttle body. Refer to Air Cleaner Inlet Duct Replacement .
  5. Remove the mass air flow (MAF) sensor. Refer to Mass Airflow Sensor with Intake Air Temperature Sensor Replacement .
  6. Remove the drive belt. Refer to Drive Belt Replacement - Accessory .
    7. Fig 1: Identifying Power Steering Pump To Power Steering Hose Banjo Bolt
    GM1949860Courtesy of GENERAL MOTORS CORP.
  7. Remove the power steering pump to power steering hose banjo bolt (1)
    8. IMPORTANT: Bolts with micro-encapsulated thread sealant must be discarded after removal.
  8. Remove the power steering pump to power steering pump bracket retaining bolts (2).
    • Discard the bolts.
    • Place the power steering pump to allow access to the alternator
    9. Fig 2: Identifying Alternator Battery Cable Nut
    GM1949858Courtesy of GENERAL MOTORS CORP.
  9. Remove the alternator battery positive cable nut (1) from the alternator.
  10. Remove the alternator battery positive cable (2) from the alternator stud.
    11. IMPORTANT: Press the retainer tabs to remove electrical connector.
  11. Remove the electrical connector (3) from the alternator.
    12. Fig 3: Identifying Alternator Retaining Bolts
    GM1951052Courtesy of GENERAL MOTORS CORP.
  12. Remove the alternator retaining bolts (1 & 2).
  13. Remove the alternator (3) from the vehicle.
scientia non olet · About LEMON Manuals