LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G6 Base, 3.5 N >> Repair and Diagnosis >> External Pages >> Different car >> Section 1345 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Steering Wheel Inflatable Restraint Module Coil Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Aligning Block Tooth & Centering Mark On Race & Upper Shaft Assembly
    GM332911Courtesy of GENERAL MOTORS CORP.
  1. To install the SIR steering wheel module coil, perform the following procedure:
    1. Aim the wheels straight ahead.
    2. Align the block tooth and the centering mark on the race and upper steering shaft at the 12 o'clock position.
    2. NOTE: The new SIR steering wheel module coil will be pre-centered. Do not remove the centering tab from the new coil until the installation is complete. If the coil does not come with a centering tab, you must center it.
  2. If centering is required, refer to Inflatable Restraint Steering Wheel Module Coil Centering .
    3. Fig 2: Identifying SIR Coil & Steering Shaft
    GM1230490Courtesy of GENERAL MOTORS CORP.
    NOTE: The new SIR steering wheel module coil will be pre-centered. Do not remove the centering tab from the new coil until the installation is complete.
  3. Slide the new SIR steering wheel module coil (2) onto the steering column (1).
  4. Connect the SIR steering wheel module coil electrical connectors.
  5. Remove and discard the centering tab from the new SIR steering wheel module coil.
  6. Install the steering column trim covers. Refer to Steering Column Trim Cover Replacement .
  7. Install the steering wheel. Refer to Steering Wheel Replacement .
scientia non olet · About LEMON Manuals