LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G6 Base, 2.4 B >> Repair and Diagnosis >> External Pages >> Different car >> Section 1473 (HVAC System - Automatic) >> Repair Instructions >> HVAC Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The key should be in the OFF position when connecting the electrical connectors to ensure proper calibration.
  1. Install the HVAC control module wire harness connectors.
    2. Fig 1: Identifying HVAC Control Module
    GM1203599Courtesy of GENERAL MOTORS CORP.
  2. Install the HVAC control module.
    3. CAUTION: Refer to Fastener Caution .
  3. Tighten the HVAC control module screws.

    Tighten:  Tighten the screws to 2.5 N.m (22 lb in).

  4. Install the I/P center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .
  5. Calibrate the actuator. Refer to Actuator Recalibration .
  6. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals