LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G6 Base, 2.4 B >> Repair and Diagnosis >> External Pages >> Different car >> Section 1432 (Engine Control System & Fuel System - 3.5L - Repair Instructions) >> Repair Instructions >> Ignition Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ignition Coil & Module Assembly & Bracket Screws
    GM1238999Courtesy of GENERAL MOTORS CORP.
  1. Install the ignition coil and module assembly to the bracket.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the ignition coil and module assembly screws.

    Tighten:  Tighten the screws to 4.5 N.m (40 lb in).

  3. Connect the spark plug wires as noted during the removal.
  4. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement .
  5. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals