LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G6 Base, 2.4 B >> Repair and Diagnosis >> External Pages >> Different car >> Section 1430 (Engine Control System & Fuel System - 3.6L - Repair Instructions) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Pontiac G6. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: MAP Sensor & Bolt
    GM1838999Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the MAP sensor O-ring seal with clean engine oil.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the MAP sensor and bolt and tighten the bolt to 10 N.m (89 lb in).
    3. Fig 2: MAP Sensor & ETC Electrical Connectors
    GM1838990Courtesy of GENERAL MOTORS CORP.
  3. Connect the engine wiring harness electrical connector (1) to the MAP sensor.
  4. Install the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement .
scientia non olet · About LEMON Manuals