LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G6 Base, 2.4 B >> Repair and Diagnosis >> Engine Mechanical >> Engine Exhaust System >> Repair Instructions >> Exhaust Heat Shield Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying Heat Shield & Nuts
    GM1787889Courtesy of GENERAL MOTORS CORP.
  1. Position the heat shield to the underbody and the dash panel.
    2. NOTE: Refer to Fastener Notice .
  2. Install the heat shield nuts.

    Tighten:  Tighten the nuts to 10 N.m (89 lb in).

  3. If equipped with a 2.4L engine, install the exhaust manifold pipe. Refer to Exhaust Manifold Pipe Replacement (LE5) .
  4. If equipped with a 3.5L, 3.6L, or 3.9L engine, install the catalytic converters. Refer to Catalytic Converter Replacement - Left Side (LZ4)  or Catalytic Converter Replacement - Left Side (LZ9)  or Catalytic Converter Replacement - Left Side (LY7)  and Catalytic Converter Replacement - Right Side (LZ4)  or Catalytic Converter Replacement - Right Side (LZ9 w/RPO M15)  or Catalytic Converter Replacement - Right Side (LY7)  or Catalytic Converter Replacement - Right Side (LZ9 w/RPO MT2) .
scientia non olet · About LEMON Manuals