LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2008 >> G5 Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 2.2L (L61) - Introduction (2 Of 2) >> Repair Instructions >> Knock Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: View of Knock Sensor
    GM630342Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice.
    IMPORTANT: The KS threaded surfaces must be clean before installation.
  1. Install the knock sensor.

    Tighten:  Tighten the knock sensor retaining bolt to 25 N.m (18 lb ft).

  2. Connect the knock sensor harness connector.
  3. Install the starter. Refer to Starter Motor Replacement .
scientia non olet · About LEMON Manuals