LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Vibe Standard >> Repair and Diagnosis >> Transmission >> Manual Transmission >> Repair Instructions >> Shift Cable Replacement >> Installation Procedure

Installation Procedure

  1. Install the shift cables in the vehicle.
    2. NOTE: Refer to Fastener Notice .
    Fig 1: Shift Cable Grommet Retaining Bolts
    GM846696Courtesy of GENERAL MOTORS CORP.
  2. Install the 2 shift cable grommet retaining bolts.

    Tighten:  Tighten the bolts to 5.0 N.m (44 lb in).

  3. Install the inflatable restraint sensing and diagnostic module from the instrument panel. Refer to Inflatable Restraint Sensing and Diagnostic Module Replacement .
  4. Install the gearshift selector assembly. Refer to Gearshift Selector Assembly Replacement .
    5. Fig 2: Shift Cable Clamp Retaining Nuts
    GM846695Courtesy of GENERAL MOTORS CORP.
  5. Install the shift cable clamp on the shift cables, then install the 2 retaining nuts.

    Tighten:  Tighten the nuts to 5.0 N.m (44 lb in).

    6. Fig 3: Transaxle Control Cables And Clip
    GM818634Courtesy of GENERAL MOTORS CORP.
  6. Connect the shift cable ends to the transaxle.
  7. Install the shift cable washers and retaining clips (1).
  8. Install the shift cables into the bracket.
  9. Install the shift cable bracket retaining clips (2).
  10. Connect the negative battery cable.
scientia non olet · About LEMON Manuals