Test Description

The number below refers to the step number on the diagnostic table.

2: If there any TAC system related DTCs set, fix those DTCs first.

DTC P2119

Step	Action	Yes	No
Schematic Reference: Engine Controls Schematics Connector End View Reference: Powertrain Control Module Connector End Views or Engine Controls Connector End Views
1	Did you perform the Diagnostic System Check - Vehicle?	Go to Step 2	Go to Diagnostic System Check - Vehicle
2	Are any other throttle actuator control (TAC) system, throttle position (TP) sensor, or accelerator pedal position (APP) sensor DTCs also set?	Go to Diagnostic Trouble Code (DTC) List - Vehicle	Go to Step 3
3	Turn ON the ignition, with the engine OFF. Clear the DTCs with a scan tool. Turn OFF the ignition for 30 seconds. Start the engine. Move the accelerator pedal from the rest position to the wide open position a couple of times. Observe the DTC Information with a scan tool. Did the DTC fail this ignition?	Go to Step 5	Go to Step 4
4	Observe the Freeze Frame/Failure records data for this DTC. Turn OFF the ignition for 30 seconds. Start the engine. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure records data. Did the DTC fail this ignition cycle?	Go to Step 5	Go to Diagnostic Aids
5	Replace the throttle body assembly. Refer to Throttle Body Assembly Replacement . Did you complete the replacement?	Go to Step 6	-
6	Clear the DTCs with a scan tool. Turn OFF the ignition for 30 seconds. Start the engine. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records. Did the DTC fail this ignition?	Go to Step 2	Go to Step 7
7	Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed?	Go to Diagnostic Trouble Code (DTC) List - Vehicle	System OK