LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Vibe Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - Introduction (2 Of 2) >> Repair Instructions >> Throttle Body Assembly Replacement >> Removal Procedure

Removal Procedure

    Fig 1: Engine Cover
    GM621681Courtesy of GENERAL MOTORS CORP.
  1. Remove the 2 nuts and the 2 retainers from the engine cover (1).
  2. Remove the engine cover (1) from the engine.
    3. Fig 2: Air Inlet Duct
    GM1455362Courtesy of GENERAL MOTORS CORP.
  3. Loosen the clamp and remove the air inlet duct (2) from the throttle body assembly (1).
    4. Fig 3: Throttle Actuator Control (TAC) Module Electrical Connector
    GM1455363Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the electrical connector (2) of the throttle actuator control (TAC) module.
  5. Drain the cooling system. Refer to Draining and Filling Cooling System .
  6. Disconnect the 2 coolant hoses (3) from the throttle body (1).
    7. Fig 4: Upper And Lower Throttle Body Fasteners
    GM1455365Courtesy of GENERAL MOTORS CORP.
  7. Remove the upper 2 fasteners (2) and the lower 2 fasteners (4) from the throttle body (3).
  8. Remove the throttle body (3) and the gasket (1) from the intake manifold.
  9. Clean any remaining throttle body gasket from the intake manifold.
scientia non olet · About LEMON Manuals