LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Vibe Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - Introduction (2 Of 2) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: CKP Sensor And Hold Down Bolt
    GM181701Courtesy of GENERAL MOTORS CORP.
  1. Install the CKP sensor (1) into the front cover of the engine block.
    2. NOTE: Refer to Fastener Notice .
  2. Install the CKP sensor hold down bolt (2).

    Tighten:  Tighten the hold down bolt to 9 N.m (80 lb in).

  3. Connect the CKP sensor electrical connector.
    4. Fig 2: Stone Shield, Four Retainers And Two Bolts
    GM830841Courtesy of GENERAL MOTORS CORP.
  4. Install the stone shield (1) with the four retainers (2).

    Tighten:  Tighten the two shield bolts to 10 N.m (89 lb in).

  5. Secure the stone shield (1) with the two bolts (3).
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals