Removal Procedure
IMPORTANT:
- Always use replacement cables that are of the same type, diameter and length of the cables that you are replacing.
- Always route the replacement cable the same way as the original cable.
- Remove the battery. Refer to Battery Replacement .
- Remove the underhood bussed electrical center (UBEC) cover.
- Remove the positive battery cable terminal nut (1) from the UBEC stud.
- Remove the positive battery cable terminal (2) from the UBEC stud.
- Remove the battery box. Refer to Battery Box Replacement .
- Disconnect the positive and negative battery cable clip (3) from the battery tray support bracket.
- Remove the positive battery cable terminal to starter solenoid nut (6).
- Remove the positive battery cable from the engine wiring harness clip (3).
- Remove the positive battery cable (4) lead from the starter solenoid.
- Cut the tape and remove the positive battery cable from the wire loom.