LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Torrent AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Wiper/Washer Systems >> Wiper System & Washer System >> Diagnostic Information and Procedures >> Windshield Wiper System Malfunction (Front) >> Circuit/System Testing >> Windshield Wiper Switch Circuit Malfunction

Windshield Wiper Switch Circuit Malfunction

  1. Ignition OFF, disconnect the harness connector at the windshield wiper switch.
  2. Ignition OFF, test for less than 20 ohms of resistance between the ground circuit terminal D and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance. If the circuit test normal, replace the BCM.
  3. Ignition ON, verify the scan tool Windshield Wiper Switch parameter is Off.
    • If not the specified value, test the signal circuit terminal E for a short to ground. If the circuit tests normal, replace the BCM.
  4. Verify the scan tool Wiper High Speed Switch parameter Inactive.
    • If not the specified value, test the signal circuit terminal C for a short to ground. If the circuit tests normal, replace the BCM.
  5. Install a 3A fused jumper wire between the signal circuit terminal E and ground. Verify the scan tool Windshield Wiper Switch parameter is Switch Fault.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
  6. Install a 3A fused jumper wire between the signal circuit terminal C and ground. Verify the scan tool Wiper High Speed Switch parameter is Active.
    • If not the specified value, test the signal circuit for a short to voltage or an open/high resistance. If the circuit tests normal, replace the BCM.
  7. If all circuits test normal, test or replace the Windshield Wiper Washer Switch.
scientia non olet · About LEMON Manuals