ECM Replacement

If the engine control module (ECM) is replaced, the following procedures must be performed:

1. ECM Reprogramming-Refer to Service Programming System (SPS) .
2. The CKP System Variation Learn - Refer to Crankshaft Position System Variation Learn .
3. Engine Oil Life Remaining-When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was replaced.
4. Transmission Fluid Life Remaining-When available, use the scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was replaced.
5. Theft Deterrent - Refer to Theft Deterrent Control Module Programming and Setup .