LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Solstice Base, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 186 (Antilock Brake System With Traction Control System & Stability Control System) >> Diagnostic Information and Procedures >> StabiliTrak Indicator Malfunction >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 Pontiac G5 and 2010 Chevrolet Cobalt. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the traction control switch.
  2. Test for less than 1 ohm between the ground circuit terminal A and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify the scan tool Traction Control Switch parameter is Inactive.
    • If not the specified value, test the signal circuit terminal C for a short to ground. If the circuit tests normal, replace the BCM.
  4. Install a 3A fused jumper wire between the signal circuit terminal C and the ground circuit terminal A. Verify the scan tool Traction Control Switch parameter is Active.
    • If not the specified value, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the BCM.
  5. If all circuits test normal, test or replace the traction control switch.
scientia non olet · About LEMON Manuals