Diagnostic Test: Self-Diagnosis Mode
WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
- Check the vehicle battery condition first (see 12 VOLT BATTERY TEST ).
- Check the navigation volume level (see owner's manual).
- Check the connectors for poor connections or loose terminals.
- If there is a Hard Error Code stored, check the Hard Error Code troubleshooting first.
- Make sure that the correct DVD color and version are installed.
- Inspect the DVD for dirt or damage.
- Before troubleshooting, make sure you have the anti-theft codes for the audio-navigation unit.
- After troubleshooting, enter the anti-theft code for the audio-navigation unit.
- The voice guidance is provided by the right front speaker. When you check the audio system function, make sure all speakers are working OK. Do the individual speaker test (see ELECTRICAL NOISE TEST ).
- Turn the ignition switch to ON (II).
- Press the SET-UP button.
- Check the volume and voice feedback setting for the navigation system in set-up.
Is either set to OFF?
YES -Set the voice feedback to ON, and select an audible level for the volume.
NO -Go to step 4.
- Check the audio system operation.
Can you hear the audio?
YES -Go to step 5.
NO -Troubleshoot the audio system.
- Check for error code in the Error History (see HOW TO CHECK ERROR HISTORY
).
Are there any Hard Error Codes stored?
YES -Refer to the Hard Error Code troubleshooting.
NO -Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).