DTC 2702: GPS Diag: Receiver in Navi ECU

WARNING: This page is about a different car, the 2011 Honda Insight and 2010 Honda Insight. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Check the vehicle battery condition first (see 12 VOLT BATTERY TEST ).
This navigation DTC sets when a problem is detected in the GPS antenna.
Before you troubleshoot, make sure to follow the general troubleshooting information (see GENERAL TROUBLESHOOTING INFORMATION ).
Make sure the vehicle is parked outside, away from buildings.
Check for electronic aftermarket accessories (possibly hidden) mounted near the GPS antenna or the audio-navigation unit.

Clear the hard error code (see HOW TO CLEAR ERROR HISTORY ).
Turn the ignition switch to LOCK (0) and then back to ON (II).
Go into the Diagnostic Menu, and select the Self-Diagnosis Mode in the Select Diagnosis items menu (see SYSTEM DIAGNOSTIC MODE ).
Select the System Links, then select the GPS Ant.

Is Receiver in Navi ECU OK indicated?

YES -Intermittent failure, the system is OK at this time. If the unit repeatedly comes back with the DTC, replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).

NO -Replace the audio-navigation unit (see AUDIO-NAVIGATION UNIT REMOVAL/INSTALLATION ).