LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> Grand Prix Base >> Repair and Diagnosis >> Brakes >> Anti-Lock Brake System, Traction Control System & Stability Control System >> Diagnostic Information and Procedures >> DTC C0141-C0156 >> Test Description

Test Description

The number below refers to step numbers on the Diagnostic Table.

  1. 2:  This step determines if the DTC is current.
DTC C0141-C0156

Step Action Yes No
Schematic Reference: Antilock Brake System Schematics 
Connector End View Reference: Antilock Brake System Connector End Views 
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2 
  1. Using a scan tool clear the DTC.
  2. Remove the scan tool from the DLC.
  3. Carefully drive the vehicle above 12 km/h (8 mph) for several minutes.
  4. Turn OFF the ignition.
  5. Install a scan tool.
  6. Turn ON the ignition, with the engine OFF.
  7. Using the scan tool in Diagnostic Trouble Codes, check for DTCs.
Did any one of the DTCs C0141-C0151 reset as a current DTC?		 Go to Step 3  Go to Diagnostic Aids
3 Replace the electronic brake control module (EBCM). Refer to Control Module References for replacement, setup, and programming.
Is the repair complete?		 Go to Step 4  -
4
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?		 Go to Step 2  System OK
scientia non olet · About LEMON Manuals