Removal Procedure
- Remove the instrument panel (I/P) accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement .
- Remove the I/P center compartment. Refer to Instrument Panel Center Compartment Replacement .
- Remove the HVAC control assembly. Refer to HVAC Control Assembly Replacement .
- Remove the radio screws.
- Pull the radio toward you.
- Disconnect the I/P wiring harness connectors and the antenna cable connector from the radio.
- Remove the radio.
IMPORTANT:
Perform the radio set up procedure for new radios. Refer to Radio Setup .