Installation Procedure

Fig 1: View of Receiver Bracket

Courtesy of GENERAL MOTORS CORP.

Inspect the receiver bracket for foam tape. If the bracket is not equipped, install foam tape as shown (1, 2) to prevent rattles.

Fig 2: View Of Digital Radio Receiver & Receiver Bracket

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice .

Install the digital radio receiver nuts.
Tighten: Tighten the nuts to 5 N.m (44 lb in).

Fig 3: View Of Rear Compartment Trim Panel & Receiver Bracket

Courtesy of GENERAL MOTORS CORP.

Align the receiver and bracket assembly to the studs.
Install the receiver bracket nuts.
Tighten: Tighten the nuts to 4 N.m (35 lb in).
Install the left rear compartment trim panel. Refer to Rear Compartment Side Trim Replacement - Left Side .
Perform the setup procedure for the digital radio receiver. Refer to Digital Radio Receiver Setup .