LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2007 >> G6 Base, 2.4 B >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System & Fuel System - 2.4L - Introduction (2 Of 2) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Identifying CKP Sensor
    GM1578475Courtesy of GENERAL MOTORS CORP.
  1. Lubricate the CKP sensor O-ring seal with clean engine oil.
  2. Install the CKP sensor.
    NOTE: Refer to Fastener Notice .
  3. Install the CKP sensor bolt.

    Tighten:  Tighten the sensor bolt to 10 N.m (89 lb in).

    4. Fig 2: Identifying Starter Solenoid Battery Cable & Nut
    GM1578421Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Ensure that the engine harness terminal (4) is still installed on the starter solenoid.
  4. Install the positive battery cable (3) to the starter solenoid.
  5. Install the positive battery cable nut (2) to the starter solenoid.

    Tighten:  Tighten the nut to 10 N.m (89 lb in).

    6. Fig 3: Identifying Engine Oil Pressure Sensor, Knock Sensor, & CKP Sensor Electrical Connectors
    GM1571236Courtesy of GENERAL MOTORS CORP.
  6. Connect the CKP sensor electrical connector (3).
  7. Install the oil level indicator tube. Refer to Oil Level Indicator and Tube Replacement .
scientia non olet · About LEMON Manuals