Installation Procedure
- Position the generator to the engine.
- Install the generator bolts.
Tighten: Tighten the bolts to 25 N.m (18 lb ft).
- Connect the engine harness electrical connector (4) to the generator.
- Install the starter solenoid wire terminal (1) to the generator.
- Install the generator harness nut (2).
Tighten: Tighten the nut to 20 N.m (15 lb ft).
- Position the starter solenoid wire boot (3).
- Install the supercharger. Refer to Supercharger Replacement .
- Connect negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
NOTE:
Refer to Fastener Notice
.