LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> General Information >> Reset Procedures >> ATEQ TPMS Reset Procedure >> ATEQ TPMS Reset Procedure

ATEQ TPMS Reset Procedure

NOTE: Unless otherwise stated, on most tire pressure sensor equipped vehicles, low tire pressure indicator lights and messages can be cleared by inflating tires to the specified pressure and driving at least 25 mph or more for a few minutes. A sensor activation tool (TPMS3) can be used in place of driving.
NOTE: After resetting, the tire pressure monitoring (TPM) system requires 60 minutes or more of driving at a speed of 19 mph (30 km/h) or above to complete the calibration process to have full capability for detecting a tire pressure condition.
  1. Adjust all tire pressures to the recommended kPa/psi.
  2. Turn ignition ON with engine OFF.
  3. Press and hold the tire pressure warning reset switch until the tire pressure warning indicator blinks 3 times at one second intervals.
  4. If the tire pressure warning indicator does not blink, repeat the procedure starting at step 2.
  5. Drive the vehicle for 60 minutes or more at a speed of 19 mph (30 km/h).
  6. Verify the system has initialized. Turn ignition ON with engine OFF and observe the tire pressure warning indicator.
    • System Initialized: light on for 3 seconds.
    • System not initialized: light on for 4 seconds.
scientia non olet · About LEMON Manuals