LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, FWD, Automatic >> Repair and Diagnosis >> Brakes >> Antilock Brake System With Traction Control System & Stability Control System >> Repair Instructions >> Wheel Speed Sensor Replacement - Front >> Installation Procedure

Installation Procedure

    Fig 1: Speed Sensor Retaining Bolt And Speed Sensor
    GM819502Courtesy of GENERAL MOTORS CORP.
    NOTE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
  1. Install the wheel speed sensor (2) to the steering knuckle. Secure with 1 bolt.

    Tighten:  Tighten the front wheel speed sensor bolt to 8 N.m (71 lb in).

    2. Fig 2: Wiring Harness, Pigtail Harness Nut And Pigtail Harness Nut
    GM819500Courtesy of GENERAL MOTORS CORP.
  2. Connect the wheel speed wiring harness (1) to the vehicle. Secure with 2 bolts.

    Tighten:  Tighten the pigtail harness nut (2) to 8 N.m (71 lb in) and pigtail harness nut (3) to 29 N.m (21 lb ft).

    3. Fig 3: Wheel Speed Sensor Electrical Connector
    GM819499Courtesy of GENERAL MOTORS CORP.
  3. Connect the wheel speed sensor electrical connector (1).
  4. Install the wheelhousing. Refer to Wheelhouse Panel Replacement in Body Front End.
  5. Perform Diagnostic System Check - Vehicle in Vehicle DTC Information.
scientia non olet · About LEMON Manuals