LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Supplemental Inflatable Restraint System) >> Repair Instructions >> Inflatable Restraint Side Impact Sensor Replacement (Front) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2005 Pontiac Vibe. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Side Impact Sensor
    GM1462757Courtesy of GENERAL MOTORS CORP.
  1. Install the side impact sensor (1).
    2. NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the side impact sensor fastener (2).

    Tighten:  Tighten the fastener to 9 N.m (80 lb in).

  3. Install the side impact sensor electrical connector.
  4. Install the front seat belt retractor. Refer to Seat Belt Retractor Pretensioner Replacement - Left Front  or Seat Belt Retractor Pretensioner Replacement - Right Front  in Seat Belts.
  5. Install the center pillar lower trim panel. Refer to Trim Panel Replacement - Lower Center Pillar in Interior Trim.
  6. Install the rear door sill plate. Refer to Door Sill Plate Replacement in Interior Trim.
  7. Install the front door sill plate. Refer to Door Sill Plate Replacement in Interior Trim.
  8. Enable the SIR system. Refer to SIR Disabling and Enabling Zones .
scientia non olet · About LEMON Manuals