LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis (Single Page) >> Electrical >> Instrument Panel System Displays, Gauges And Console >> Repair Instructions >> Multifunction Alarm Module Replacement >> Removal Procedure

Removal Procedure

    CAUTION: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
  1. Disconnect the negative battery cable.
    2. IMPORTANT: The multifunction alarm module is located under the instrument panel on the drivers side.
  2. Remove the screws from the junction block and position the junction block in order to gain access to the multifunction alarm module.
    3. Fig 1: Multifunction Alarm Module And Junction Block
    GM432041Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the multifunction alarm module electrical connector.
  4. Disconnect the multifunction alarm module (1) from the rear of the junction block (2).
scientia non olet · About LEMON Manuals