LEMON Manuals: Even more car manuals for everyone
Home >> Pontiac >> 2006 >> Vibe Base, AWD >> Repair and Diagnosis (Single Page) >> Accessories & Equipment >> Infotainment >> Cellular Communication Systems >> Repair Instructions >> Communication Interface Module Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Positioning Vehicle Communication Interface Module
    GM1528369Courtesy of GENERAL MOTORS CORP.
  1. Position the VCIM in the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts (1).

    Tighten:  Tighten the nuts (1) to 4 N.m (36 lb in).

    3. Fig 2: Identifying Cellular Antenna And Navigation Radio Antenna Connectors
    GM1528368Courtesy of GENERAL MOTORS CORP.
  3. Position the seat to the most rearward position.
  4. Connect the cellular antenna and the navigation radio antenna connectors (1).
    5. Fig 3: Identifying Vehicle Communication Interface Module Electrical Connectors
    GM1528367Courtesy of GENERAL MOTORS CORP.
  5. Connect two vehicle communication interface module electrical connectors (1).
    6. CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.
  6. Connect the battery ground cable.
    7. IMPORTANT: If replacing the vehicle communication interface module, you must reconfigure the OnStar® system.
  7. Reconfigure the OnStar® system. Refer to Communication Interface Module (OnStar) Programming and Setup in Programming and Setup
scientia non olet · About LEMON Manuals